Up to 16 GB memory cards can be used Report Jpeg and BMP reports LCD Display Active Area W: 108 mm (4.25”) x H: 64.8 mm (2.55”) Size 5.0” Pixel Resolution 800 (W) x 480 (H) dot Connectors Probe Connectors Two LEMO-00 UT Output Connector SAP output, Alarm USB Interface micro USB connector SD-Card Connector Full size SD card slot to accommodate standard SD cards Pulser - All pulser measurements taken according to EN12668 specifications Pulser Mode Simulated spike standard, Uni-polar square wave optional Pulser Voltage (SQ Mode) 120 V to 300 V with 10 V step in a tolerance of 10% Pulser Width (SQ Mode) 30 ns to 500 ns with 10 ns step in a tolerance of 10% Pulser Amplitude (Spike Mode) Low: 120 V, High: 300 V Damping 50 or 1000 Ohms PRF Automatically optimized between 15 Hz to 2000 Hz, 3 automatic adjustment modes: AutoLow, Auto Med, AutoHigh - Optional manual control of PRF from 15 to 2000 Hz. CRxFlex is a trademark of GE Sensing & Inspection Technologies GEIT-20056EN(08/09) Gate Independent Gates 2 gates (A and B), Gate B supports triggering by gate A Rectification Positive (POS) Full wave (FW) Negative (NEG) RF Measurement Peak JFlank Memory Capacity 2 GB SD Card.
Other company or product names mentioned in this document may be trademarks or registered trademarks of their respective companies, which are not affiliated with GE. GE is a registered trademark of General Electric Company. Specifications are subject to change without notice. Technical Specifications - USM Go © 2009 General Electric Company.